Sunday, April 1, 2012

Prints

Here are some examples of prints from my rewrap Huxley.  I have been experiencing some banding which is likely caused by my Z leadscrews.  I'm not overly concerned since my Prusa will be printing by the end of the week.  I would post pictures of my Prusa build but there is plenty of documentation on that model.

Fishbone gears for Wade's Extruder
 Hollow Owl at 35% scale and 12 tooth T5 pulley  http://www.thingiverse.com/thing:18218
 1.5 scale Love Loft Box http://www.thingiverse.com/thing:18656
 50% scale hollow Stanford Bunny. http://www.thingiverse.com/thing:3731

My tool chain is:

Pronterface host software.  Slic3r/Skeinforge/SFACT (Depending on print).  RAMPS 1.4 with Marlin Firmware.

No comments:

Post a Comment